Fitment

How to measure for a tonneau cover?

To measure for a tonneau cover, record your truck bed's length from the front bulkhead to the inside of the closed tailgate, then confirm it against your truck's make, model and year.

How to Measure Your Truck Bed for the Right Size Before Buying a Tonneau CoverSummit Racing · 2:09

A tonneau cover must match your exact bed length, and the same truck model can ship with different bed sizes. Measuring the bed yourself catches this mismatch before you order. Cover makers list fitment by truck and bed length, so your reading and your model year should agree before you buy.

  • Two trucks with the same make, model and year may use different tonneau cover bed lengths.
  • A tonneau cover is sold to fit a specific bed length, not a general truck size.
  • Bed length is measured in inches, from the front bulkhead to the inside of the closed tailgate.
  • Truck make, model and model year are the three details a cover's fitment listing is matched against.

01Step-by-Step

  1. Close the tailgate: Raise the tailgate fully and latch it, so the bed length you measure matches what a cover will actually span when it is installed.
  2. Clear the bed: Remove cargo, mats, and any bed liner lip or toolbox that sits against the front wall and could throw off the reading.
  3. Measure the length: Run a tape from the inside face of the front bulkhead to the inside face of the closed tailgate along the floor, in inches.
  4. Check the width: Measure across the bed between the inner walls, then take it again near the tailgate, since many beds narrow slightly toward the rear.
  5. Repeat once more: Take the length a second time along the opposite side of the bed floor, and use the larger reading if the two differ by a fraction of an inch.
  6. Note your truck details: Write down the make, model, and model year, since fitment listings match your truck against the bed length you just recorded.
  7. Compare against the listing: Find the cover's stated bed length for your truck and confirm it agrees with your measurement before ordering.